Filter
Top Products
2. Lift out the full dust bag Fig.6/2
3. Dispose the full dust bag and
insert a new dust bag into the
vacuum cleaner. Align the
front of the dust bag with the
air entrance.
NOTE: The seal ring around the
dust bag opening should cover
the air entrance connector
inside the housing.
Pre-motor Filter (Model VCC-05 only)
1. Turn off the vacuum cleaner
and unplug it from the electrical
outlet.
2. Unclip the retainer clip on the
top of the vacuum cleaner and
lift up to gain access to the dirt
container department. (Fig.6/3)
3. The pre-motor filter is found in
the centre of the dirt container.
Rotate the filter retaining disc
anti-clockwise to gain access to
the filter (Fig.6/4).
4. The pre-motor filter can be lifted
out. (Fig.6/5)
NOTE: Vax recommends
replacing the premotor filter
when it becomes discoloured.
5. Replace with a new filter inside
and turn the retaining disc
clockwise to secure. (Fig.6/6)
98
Fig.6/2
Fig.6/4
Fig.6/6
Fig.6/3
Fig.6/5
HEPA Pre-motor Filter (Model VCC-07 only)
1. Turn off the vacuum cleaner and
unplug it from the electrical outlet.
2. Unclip the retainer clip on the top of
the vacuum cleaner and lift up to
gain access to the dirt container
department (Fig.6/8).
3. The HEPA pre-motor filter is found
in the centre of the dirt container.
Rotate the filter clockwise to remove
(Fig.6/9).
4. Gently tap the filter against the side
of the rubbish bin to remove excess
dirt. The filter may then be rinsed in
cool water. Allow to thoroughly air
dry before replacing. Replace the
filter every 3-6 months depending
on usage or when the filter
becomes discoloured (Fig.6/7).
NOTE: Do NOT use any detergents or
boiling water to wash the filter.
5. Replace the HEPA filter back in the
machine before use.
5. DIRT CONTAINER (CONTINUED)