Filter
Top Products
Maintenance
(ii)
(iii)
The Hoover HandiVac 14.4 comes with a Floor extension tool.
This allows your hand-held vacuum to reach difficult spaces such
as down small spaces, ceiling cornices, along shelves or simply
down to the floor.
The four parts assemble easily. Insert the Inlet Fitting (part iii) into
the inlet of the hand-held vacuum. This will fit firmly in place.
Then take the two extension tubes (part ii) and join together.
Once together, one end will then fit into the Inlet Fitting (part
iii). Finally push the soft brush (part i) into the open end of the
extension Tube (part ii). You are now ready to extend the use
of your hand-held vacuum.
These extra parts are able to
conveniently store on the
special Floor extension Tool
storage adaptor to your
Charging base – as shown
in Figure 2.
Figure 3 shows extension
Tool assembly.
Fig. 1
Fig. 2 Fig. 3
Floor Extension Tool - 14.4V (7220) Only