6
Manual Control Operation (Models HWM-330 and HWM-331)
POWER
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH
WET HANDS AS AN ELECTRICAL SHOCK COULD
OCCUR.
• With the power switch in the OFF position, plug the filled humidifier
into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG
INTO THE OUTLET; it will only fit one way.
OUTPUT / MOISTURE CONTROL
• Set the Moisture Control knob to the desired position (Fig. 7).
HIGH: For fast humidifying
LOW: For everyday moisture control
• Continuous Mode - Your unit will run continuously at your selected output level until you shut it off or it
runs out of water.
ADVANCED MIST™ HUMIDISTAT
The Advanced Mist
™
Humidistat allows you to adjust and select the
humidity level to your personal preference. Your humidifier will turn on
and off throughout the day and night to maintain the desired humidity
level you have selected.
HOW TO SET THE HUMIDISTAT
First, turn the Humidifier on and select your moisture/output level. Set
the Advanced Mist
™
Humidistat on HIGH by turning the knob clockwise
to the end (Fig. 7).
• Let the humidifier run on high for a least one hour
or until your room
has reached a comfortable humidity level.
• At this point, slowly turn your Humidistat knob counter-clockwise until the humidifier shuts off
(Fig. 8).
• Now that your Humidistat knob is set, the humidifier will automatically turn back on when your room
drops below your comfort setting and will automatically turn off again when the setting is reached.
NOTE: If the humidifier will not start or restart when you select a moisture level, the Advanced Mist
™
Humidistat may be set too low. Turn the dial clockwise to the end (Fig. 7).
REFILL / CLEAN HUMIDIFIER
• When the Refill/Clean indicator light is illuminated it implies your unit
is out of water or you need to clean your humidifier (Fig. 9).
• Check your water level. If your Tank is empty, turn your Power knob
to the OFF position, remove the Tank and refill it as described in the
FILLING section.
• If your water level is full, this implies it’s time to clean your
humidifier. Please turn off and unplug the unit and refer to the
CLEANING section.
NOTE: Your unit’s performance will decrease if you do not clean
your heating plate. Your unit may continuously shut off and output
will decrease.
NOTE: Do not turn on the unit until the tank is refilled and reinstalled.
Refill/
Clean
Fig. 7
Fig. 8
Moisture
Control
Knob
Humidistat
Knob
Power
Light
(Illuminated)
Fig. 9
Refill/Clean Light
(Illuminated)
QuickSteam_OM_04-25-06.qxd 4/25/06 4:53 PM Page 6