Filter
Top Products
CAUTION: HOT STEAM MAY CAUSE SEVERE BURNS
DO NOT TOUCH THE MEDICINE CUP UNTIL IT HAS COOLED.
Soothing vapor can be distributed into the air by using the Medicine Cup
at the top of the unit. To add medicine to the Medicine Cup:
• Turn the humidifier OFF and wait 10 minutes for the unit to cool.
• Remove the Medicine Cup from the unit by pulling firmly upward
(Fig. 21).
• Fill the cup halfway with liquid medicine. Only place the medicine
in the small oval area. Do not put medicine in the grille area.
• Carefully reinstall the Medicine Cup back into the unit.
• After use, remove and clean the Medicine Cup with warm water. Reinstall the clean and dry Medicine
Cup into the unit.
WARNING: DO NOT use any liquid medicines other than those specifically recommended for use
with steam vaporizers or warm HUMIDIFIERS. DO NOT pour medicine through the front or side
grilles or add it to the water tank.
Kaz assumes no responsibility for consequences resulting from the use of medicine in this humidifier.
Fig. 21
Place
medicine
here
Medicine Cup
10
CAUTION: DO NOT CLEAN THE HUMIDIFIER WITH THE
POWER CORD PLUGGED IN THE ELECTRICAL OUTLET
AS AN ELECTRICAL SHOCK COULD OCCUR.
We recommend cleaning the humidifier once a week. It may require
cleaning more often if you have hard water, notice a build up of
impurities or detect unpleasant odors. The importance of routine
cleaning and care cannot be over emphasized.
Cleaning involves two steps: SCALE REMOVAL and DISINFECTING.
Be sure to perform these in the proper order to avoid harmful
chemical interactions.
• First, turn off and unplug the humidifier. Wait at least 10-15 minutes for the unit to cool.
• Remove the Water Tank.
• To remove the Power Unit, grasp the Power Unit and lightly tilt
forward while pulling up. You will feel the unit disengage from its lock
(Fig. 22). Set the Power Unit aside.
• Remove the Water Tray (Fig. 23) and set aside. Be sure to
thoroughly clean the Water Reservoir in the Base. Minerals often
accumulate in this area, so special attention should be used.
• Empty any water from the Base and Removable Tray.
• Be sure the Heating Plate has cooled sufficiently.
• Remove the Mineral Absorption Pad using tweezers or tongs and
check the condition of the Mineral Absorption Pad and the Heating Plate found on the Base. If build-up of
minerals is heavy, follow the Cleaning the Heating Plate instructions.
CAUTION: DO NOT SUBMERGE THE BASE IN WATER. DOING SO MAY CAUSE PROPERTY
DAMAGE OR PERSONAL INJURY. ALLOW THE HUMIDIFIER TO DRY COMPLETELY BEFORE
PLUGGING INTO POWER OUTLET.
Weekly Cleaning
Fig. 22
Base
Power
Unit
Fig. 23
Removable
Water Tray
Mineral Reservoir
Base
QuickSteam_OM_04-25-06.qxd 4/25/06 4:53 PM Page 10