Honeywell VR8304 Boiler User Manual


 
69-12254 G.R. Rev. 9-00 www.honeywell.com
Home and Building Control Home and Building Control
Honeywell Inc. Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, Minnesota 55422 Scarborough, Ontario
M1V 4Z9
VR8104, VR8204 AND VR 8304 INTERMITTENT PILOT COMBINATION GAS CONTROLS
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
INSTRUCTIONS TO THE
HOMEOWNER
WARNING
Fire or Explosion Hazard.
Can cause property damage, severe injury,
or death.
Follow these warnings exactly:
1. Pilot flame is lit automatically. Do not light the
pilot flame manually.
2. Before lighting the pilot burner flame, smell
around the appliance for gas. Be sure to smell
next to the floor because LP gas is heavier
than air. If you smell gas:
Turn off the gas supply at the appliance
service valve. On LP gas systems, turn off
the gas supply at the gas tank.
Do not light any appliances in the house.
Do not touch electrical switches or use the
phone.
Leave the building and use a neighbors
phone to call your gas supplier.
If you cannot reach your gas supplier, call
the fire department.
3. Replace the gas control in the event of any
physical damage, tampering, bent terminals,
missing or broken parts, stripped threads, or
evidence of exposure to heat.
IMPORTANT
Follow the operating instructions provided by
the heating appliance manufacturer. The
information below describes a typical control
application, but the specific controls used and
the procedures outlined in your appliance
manufacturer instructions can differ, requiring
special instructions.
STOP: Read the Warnings Above Before
Proceeding.
The pilot flame is lit automatically. If the appliance does
not turn on when the thermostat is set several degrees
above room temperature, follow these instructions:
1.
Set the thermostat to its lowest setting to reset the
safety control.
2.
Disconnect all electric power to the appliance.
3.
Remove the burner access panel if provided on
your appliance.
4.
Turn the gas control knob clockwise to the
OFF position.
5.
Wait five minutes to clear out any unburned gas.
Then if you smell gas, STOP! Follow Step 2 in the
Warning above. If you do not smell gas, continue
with the next step.
6.
Turn the gas control knob counterclockwise
to the ON position.
7.
Replace the burner access panel.
8.
Reconnect all electric power to the appliance.
9.
Set the thermostat to the desired setting.
10.
If the appliance does not turn on, turn the gas
control knob to the OFF position and contact a
qualified service technician for assistance.
Turning Off the Appliance
Vacation Shutdown
Set the thermostat to the desired room temperature while
you are away.
Complete Shutdown
Turn off power to the appliance. Turn off the gas supply
to the appliance. Turn the gas control knob to OFF. The
appliance will completely shut off. Follow the procedure
in the Instructions to the Homeowner section above to
resume normal operation.