Filter
Top Products
– 26 –
Macro Key Programming & Usage
Macro Key Programming & Usage Macro Key Programming & Usage
Macro Key Programming & Usage
(cont.)
(cont.)(cont.)
(cont.)
The keypad beeps to acknowledge your input and
displays the command you entered (followed by “F”).
3. Enter the next command, followed by press/holding
the “D” key for at least two seconds. The keypad
beeps and displays the keystrokes entered so far.
4. Repeat until all the desired commands (up to 16
characters including the “F”s) have been entered.
Be sure to check your keystrokes before continuing.
If you made a mistake, you must start over.
5. To exit, press/hold the “D” key for at least two
seconds. The display returns to system status and
indicates system is ready.
Typical Macro Alpha Display:
MACRO PGM
6 0 2 0 3 F
#
7 0 1 F 2 F
Example of
Example of Example of
Example of Macro Programming
Macro ProgrammingMacro Programming
Macro Programming
Suppose you want to (1) bypass the two upstairs window zones, then (2) turn on an exterior
light, and then (3) arm the security system in the AWAY mode. The procedures in the table
that follows show you how you would program this macro:
Function
Keystrokes Required Keypad Display
1. Bypass zones 02 &
03
Press
BYPASS [6]
key, then
2-digit zone number 02, then
terminator “D”’ then [6], then 2-digit
zone number 03, then terminator “D”.
6 0 2 F 6 0 3
2. Insert terminator. Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F
3. Turn light on
(device 01).
Press [#] and 7 keys for “device ON”,
and [01] key for selecting device 1.
6 0 2 F 6 0 3 F
#
7 0 1 F
4. Insert terminator. Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F
#
7 0 1 F
5. Arm system AWAY
Press
AWAY [2]
key.
6 0 2 F 6 0 3 F
#
7 0 1 F 2
6. Insert terminator. Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F
#
7 0 1 F 2 F
7. Exit Macro mode Press the “D” key again.
Using a Programmed Macro Key
Using a Programmed Macro KeyUsing a Programmed Macro Key
Using a Programmed Macro Key
DISARMED
READY TO ARM
1.
Press the Macro key programmed for the desired
series of commands for at least 2 seconds. The “Enter
User Code” prompt appears. The prompt remains
displayed for up to 30 seconds.
ENTER USER CODE
* * * *
2.
Enter your 4
-
digit
security
code.
The programmed macro sequence begins
automatically after the user code is entered.