Filter
Top Products
17
17
and alarm icon will flash once the remote temperature for
Channel One (1) will reach 32°F(0°C) and below.
NOTE: Ice Warning Alarm can be set only if one or both - Weekday
or Single alarm are programmed.
SETTING THE WEEKDAY (W) AND SINGLE DAY(S) ALARMS
· Press ALARM ON/OFF button once to enter into the alarms
setting mode. The default alarm is a Weekday alarm (W). The
abbreviation “OFF” with a letter “W” next to it will be displayed, if
the alarm has not been set previously.
· Press and hold ALARM ON/OFF button for two seconds. The
hour digit will flash.
· Enter the hour using UP (▲) or DOWN (▼).
· Press ALARM ON/OFF again. The minute digits will flash.
· Enter the minutes using UP (▲) or DOWN (▼).
· Press ALARM ON/OFF button again to confirm and the weekday
alarm time will be set.
· Set Single day alarm if desired in the same manner.
SETTING THE ICE WARNING ALARM (PRE-AL)
If Weekday or Single day alarm is set, the Ice Warning Alarm can be
programmed.
· Press ALARM ON/OFF button once to enter into the Ice Warning
Alarm setting mode. The abbr eviation “OFF” with a “PRE-AL”
next to it will be displayed.
· Press and hold ALARM ON/OFF button for two seconds. The
“30” number will flash, meaning that if selected, the alarm will
sound 30 minute s earlier than the Weekday or Single alarm.
· Select the desired Ice Warning Alarm interval in 15 minutes
18
increments between 15 and 90 minutes , using UP (▲) or DOWN
(▼)buttons
· Press ALARM ON/OFF button again to confirm and exit from the
alarm setting mode.
ACTIVATING THE ALARM
· Press ALARM ON/OFF button to enter into the alarms mode.
· Press UP (▲) to activate or DOWN (▼) to deactivate desired
· If alarms are activated, the corresponding icons W, S or PRE-AL
will be displayed.
SNOOZE
When any alarm sounds, press the SNOOZE/LIGHT button to temporarily
stop the alarm. The alarm sound will resume in five minutes. If the alarm
is not disabled after that, it will sound for four more minutes and then will
stop by itself.
PROJECTION
The Weather Forecaster is capable of projecting images for a short period,
as well as continuously. This require both batteries and power adapter.
TIME AND REMOTE TEMPERATURE PROJECTION
· Press SNOOZE/LIGHT button once to project the current time
and the remote temperature image for five seconds.