Filter
Top Products
– 25 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Using Powerline Carrier Device Commands
(Lights On/Lights Off Keys)
General Information
Powerline Carrier devices (e.g. X10 brand devices) are programmable switches that can be used to
perform many different functions. Your system may be set up so that certain lights or other devices can
be turned on or off by using the device command from the keypad. Ask your installer if this has been
done in your system. If programmed for your system, some devices may activate automatically upon
certain system conditions. In this case, the following commands can be used to override the device
activation. See your installer for a full explanation of this feature.
To activate X10 devices 01-06: FUNCTION + LIGHTS ON + (2-digit) dev. no. (2 beeps)
To deactivate X10 devices 01-06:
FUNCTION + LIGHTS OFF + (2-digit) dev. no. (2 beeps)
To activate X10 devices 07 & 08**: +FUNCTION +LIGHTS ON + (2-digit) dev. no. (2 beeps)
Your user code
To deactivate X10 devices 07 & 08**:
+FUNCTION +LIGHTS OFF + (2-digit) dev. no.
Your user code (2 beeps)
** Devices 07 and 08 may be assigned to system devices, such as alarm bells, which should not be activated using
this command because they are activated automatically under certain system conditions. See your installer and
the table below. Devices 09-16 are used for Multi-Mode (e-mail event triggers.
Device Descriptions
See your installer for device numbers assigned for your system.
Device Description
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16