Filter
Top Products
6
Fig. 5
SAFETY FEATURES
The Honeywell Infrared Heater is equipped with several devices and features for added protection:
• Cool to touch housing and handle.
• A four way tip-over switch that disables the heater if it is accidentally tipped in any front, back or side to side directions.
• A high temperature safety control prevents overheating. See troubleshooting section.
• Equipped with an overheat switch that will shut down the unit.
• This heater was created using a high quality safety plastic.
• Periodic cleaning of the lter is recommended. Turn the heater O ( ) and unplug it. Allow it to cool. Remove the Filter Cover and
clean/vacuum the Filter.
• It is recommended that the Infrared Heater be cleaned at least once a
month and before o-season storage.
• Turn the heater O ( ) and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater.
DO NOT USE WATER, WAXES, POLISHES OR ANY CHEMICAL SOLUTION.
• Clean the Infrared Heater using the above-mentioned steps.
Wrap the cord around the unit. Place in its original box and store
it in a cool, dry place.
• This heater does not disassemble.
• Press and hold both Thermostat Control Buttons ( ) for three seconds to change between Fahrenheit and Celsius and back.
NOTE: The Remote will not change between Fahrenheit and Celsius - only the controls on the heater.
CLEANING AND STORAGE
FAHRENHEIT TO CELSIUS
OPERATION (continued)
• The MyTemp Settings ( ) allow you to pre-set two favorite heat
settings and the timer function.
- To set a MyTemp preference, choose any heater setting (heat and/or
timer) and hold a MyTemp button for 3 seconds (Fig. 5), until it beeps.
The MyTemp Button will ash then illuminate and your favorite setting
is stored. It can be re-set at any time.
NOTE: Both MyTemp Settings will default to Constant High (L3) at rst
operation until you choose your favorite setting.
- To exit from a MyTemp Setting, simply press any Thermostat Control
Button ( ) to choose another setting.
• To select a pre-set MyTemp Setting – simply press the MyTemp Button and the heater will run in that favorite mode.
• To shut the heater o, press the Power Button ( ) and the heater will begin Powering Down as displayed in Status by a
blinking light. The heater will automatically shut o in about 60 seconds after the fan cools the internal components.
Fig. 6
Filter
Filter Cover