Filter
Top Products
READ AND SAVE THESE
IMPORTANT SAFETY
INSTRUCTIONS BEFORE
USING THIS FAN.
When using electrical
appliances, basic safety
precautions should
always be followed,
including the following:
• Use this fan only as
described in this manual.
Other use not
recommended may
cause fire, electric shock
or injury.
• High Velocity fans are
designed to create rapid
air movement; therefore,
make sure the fan is not
placed near drapes,
curtains, or any objects
that may be drawn into
the fan.
• To protect against
electrical shock, do not
immerse unit, plug or
cord in water or spray
with liquids.
• This fan requires a
grounded 120 volt
power source (3 prong
receptacles).
NEVER CONNECT THIS
FAN TO ANY POWER
SOURCE OTHER THAN
A PROPERLY GROUNDED
120 VOLT AC
RECEPTACLE. DO NOT
ATTEMPT TO DEFEAT
THIS SAFETY FEATURE.
• Close supervision is
necessary when any
appliance is used by
or near children.
• Turn the fan to the OFF
position and unplug the
fan from the outlet when
not in use, when moving
fan from one location to
another, servicing parts
and before cleaning.
• Do not operate fan in
the presence of explosive
and/or flammable fumes.
• Do not place the fan or
any parts near an open
flame, cooking or other
heating appliance.
• Do not operate the fan
with a damaged cord or
plug, after a malfunction
or if dropped or damaged
in any manner. (See
warranty)
• Avoid contact with
moving fan parts.
• To disconnect, grip the
plug and pull it from the
wall outlet. Never pull
by the cord.
• The use of attachments
not recommended by
Honeywell Consumer
Products may be
hazardous.
SAFETY INSTRUCTIONS
• Always use on a dry,
level surface.
• Do not hang or mount
fan on a wall or ceiling.
• Do not operate without
the fan grilles properly
in place.
• Be sure to center this
fan when using it on an
elevated surface and be
careful not to place the
fan too close to the edge
of that surface.
• Do not use outdoors.
• Do not let the power
cord hang over the edge
of a table or counter or
let it touch any hot
surfaces.
• A loose fit between the
AC outlet and plug may
cause overheating of the
plug. Have a qualified
electrician replace
the outlet.
WARNING: To reduce the
risk of fire or electrical
shock, DO NOT USE THIS
FAN with any SOLID
STATE Speed Control
Device.