Honeywell HCM-630 Humidifier User Manual


 
8
STEP 4: SET HUMIDITY
• You can set your desired humidity in 1% increments anywhere
from 25% to 65%.
• To set your desired humidity, press the humidity button ( )
up or down (Fig. 12).
• When the display indicates your desired humidity setting wait 3
seconds.
• After 3 seconds your desired humidity is set and the display
will revert back to showing the current room humidity.
NOTE: If you wish to change your humidity setting or check to
see what you set, simply press the humidity button once and it
will show you the set humidity. If you want to change it,
continue to push the button up or down until you have reached
your new desired humidity. Again, after 3 seconds the display
will revert to showing the current room humidity.
• Once you have set your humidity the unit will operate under
this setting until the unit is turned off or your selected humidity
is reached.
• When your desired room humidity has been reached the fan
will shut off and the house icon ( ) on the top of your display
will illuminate (Fig. 13). It will stay illuminated until your desired
humidity decreases at which time the fan will turn back on.
NOTE: Your room humidity can often fluctuate. It is normal for your
unit to turn itself on and off throughout the day as it is monitoring
your changing environment.
Digital EasySet
Control Operation (Model HCM-650)
Fig. 12
The Protec
Cleaning Cartridge will last 30 days or longer, depending on your usage. To install or replace
your cartridge, simply remove the holder on the inside of your tank cap by turning it counter-clockwise .
Replace the cartridge holder by by turning it clockwise (Fig. 14 & Fig. 15).
Protec
Cleaning Cartridge
Fig. 14
Cartridge
Holder
Protec
Cleaning
Cartridge
Tank Cap
Fig. 15
Fig. 13
QuietCare_OM_Rev2.qxd 5/16/06 5:47 PM Page 8