Filter
Top Products
Rev 2.0
63-7048 1998 Honeywell Inc.
Page 20 of 22
a ¾” diameter hole to be cut in the duct. Drilling this hole with a uni-bit is a
snap. Simply drill the hole, place the control on the duct, and secure it with self-
tapping screws.
Figure 14 – H1008 Sensors
This method of mounting greatly improves the sealing of the return air duct.
Building inspectors sometimes require leaks around the rectangular cutouts to
be sealed by caulking.
3.
Simple Wiring
Large screw terminals are used, with guides to hold the wires while tightening
the screws – no micro-miniature terminal blocks here. Terminals are well
labeled and intuitive (see Figure 15).
Figure 15 – H1008 Wiring Terminals