Filter
Top Products
• CONNECT THE BATTERY. The programmable controls and real time clock are
battery backed. Upon initial set-up, pull the protective film from the battery door so
the battery will make contact and function (Fig. 2). This
battery allows you to temporarily unplug your air cleaner
without losing program settings.
• INSTALL PRE-FILTER BEFORE USE. Locate the initial
pre-filter in the packaging. Refer to the "How to Install and
Replace the Filters" section for proper installation.
• SET CURRENT TIME. Plug unit in outlet.
NOTE: The air cleaner cannot be programmed unless it is
plugged into the outlet. Hold SET button down for
approximately 3 seconds. The clock icon and word TIME will appear. You may
adjust the hours using the up button and adjust the minutes using the down button.
After the current time is set, repeatedly press SET button until ( ) disappears.
Set-Up
The default program setting upon initial start-up is Manual Operation.
• To go from Automatic Operation to Manual Operation press the PROGRAM button
until both PG1 and PG2 disappear.
• To change the speeds in Manual Operation mode press the SPEED button to
select the desired setting.
• The SPEED button will move through HIGH, MED, LOW, and OFF as noted on the
display, and will function independent of programmed settings.
Manual Operation
Programmable Control Features
Fig. 1
Your programmable control features include (Fig. 1):
• Manual control or automatic programmed operation
• 3 Speed settings
• Customize set program times
• Clock
• Intelli-Check
TM
Pre-filter life monitor bar
• Intelli-Check
TM
HEPA filter life monitor bar
• Filter reset function
• Low battery indicator
speed
filter
minutes
Fig. 2
035-00438 17005 OM eng/fr/sp 8/3/01 12:44 PM Page 4