Filter
Top Products
Assembly and Instructions for Use
1. Unpack the product and place on a horizontal
surface on top of the waterproof black mat
provided. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump
speed is controlled by the dial located at the front
of the pump. The speed is indicated by a “min”
and “max” (Fig 1). At its highest speed level, the
dial will cease to move any further. To decrease
the pump speed, move the dial counter-clockwise
toward the “min”sign. Similarly, at its lowest
speed, the dial will cease to move any further.
3. Insert the plastic tubing into the pump. Place
pump into fountain lower basin (Fig 2).
4. Fill the lower basin with clean water. The water level
should be approximately
1
/2 an inch below the steel
net (Fig 3). NOTE: Distilled water is
recommended for easier maintenance.
5. Attach the A/C adaptor jack to the base power
cord. DO NOT plug into outlet at this time. (Fig 2)
6. Insert light & sound cord through hole in top basin
and insert into plug on bottom of lid. Then screw
housing clockwise until tight. (Fig 4)
4 5
Figure 2
Figure 1
Figure 3
Figure 4
Sound Selection
Music Speaker
Light
Switch
Lock
Light & Sound
Cord
Plastic Tubing
Pump
On/Off Switch
Base Power
Cord
Adaptor
Lower Basin
Water Flow Dial
Water Flow Dial
Volume
Dial
Steel
Net
BACK VIEW
FRONT VIEW
Light &
Sound Plug
Cleaning Pin
Locks
L.E.D. Lights
Water Flow Dial
7. Tilt lid forward and line up the hooks
of the lid with the square locks of the
top basin. Then place flat onto
fountain top and slide lock switch
(Fig. 2) to hold securely in place.
8. Plug the power cord into a 120V
household outlet. The fountain &
sound machine are controlled by the
switch on the power cord. To operate
Rain Forest Fountain, turn on by
rotating switch on cord (Fig. 2). If
fountain doesn’t operate, rotate switch
once to turn on and once more to turn
off to reset. NOTE: Unit power must
be “ON” in order for both the fountain
and sound machine to operate.
9. To use light, flip switch on the back of
the fountain lid (Fig 2). Light will con-
tinuously change colors.
10. To adjust rainfall speed, turn the water
flow dial (Fig 2) clockwise to increase
the rainfall and counter-clockwise to
decrease. When dial stops in
counter-clockwise motion, rainfall will
come to a stop.
11. To use sounds, turn volume dial
(Fig 3) counter-clockwise to turn on.
Then select your nature sound by
pressing the sound button of your
choice. Volume can be adjusted by
turning the volume dial – counter-
clockwise to increase volume and
clockwise to decrease volume.
12. To Turn sounds off either:
a. Press the off button on the lid to
retain your volume setting for the
next use, or
b. Turn the volume dial clockwise until
it clicks off.
13. Turn fountain & sound machine off by
turning the switch on the power cord.
NOTE: Main power switch must be used
to turn unit completely on or off.
- Fountain can be used independent
of sound machine
- Sound Machine can be used with-
out fountain water flowing, although
pump will remain on unless main
“on/off” switch is turned off.