CAUTION CONTINUED
• The electrical cord of this product cannot be replaced. If it sus-
tains damage, you must stop using this product immediately
and return it to the HoMedics Service Center for repair. (See
the warranty section for HoMedics address.)
• Disconnect the appliance from outlet before putting hands
into water.
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Lead the cord through the cord slot on the bottom of
the Base (Fig. 2). This will ensure that the unit is
balanced when placed on a flat surface. Attach
Adaptor to the Power cord. DO NOT plug into outlet at
this time (Fig. 3).
3. Attach Leaf 1 to the Base by inserting the Pole into to the
Water Supply Hole on the Pump Stand (Fig. 1).
4 5
4. Attach Leaf 3 to the
corresponding hole in
the base (Fig 1).
Please note water
flows from two
directions. Match leaf
position shown (Fig. 3)
and adjust as needed
to avoid water flowing
outside of base.
5. Align the Half-circle cutout at the
underside of Leaf 2 with the Half-
circle extension from the ‘7’
shaped stand and firmly connect.
Next, insert the ‘7’ shaped stand
into the base (Fig 1).
6. Add clean water into the base
(about 28 oz). The water level
should be even with the
Fill Line (Fig. 4).
7. Arrange Stones provided on
Leaf 1, Leaf 2, Leaf 3, and in the
Base as desired (Fig. 5).
8. Plug the cord into 120V household
outlet. The fountain is controlled by
the switch located on the power
cord. If pump doesn’t operate,
rotate in-line switch once to turn
“on” and once more to
turn “off”. NOTE:
Ensure that the electri-
cal cord loops below
the electrical outlet to
form a ‘Drip Loop’
(Fig. 6). This will prevent
water from running
down the cord into the
electrical outlet.
Figure 2
Stones
Leaf 1
Leaf 2
Leaf 3
Half-circle
extension
‘7’ Shaped Stand
Pump Stand
Fill Line
Water
Power Cord
Switch
Adaptor
Base
Screws
Half-circle
cutout
Pole
Water Supply
Hole
Figure 1
Drip Loop
Figure 6
Figure 4
Figure 5
Figure 3
Leaf 1
Leaf 3
Water Flows Here
Front of Base
‘7’
Shaped
Stand