Filter
Top Products
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)
2.
Assemble the fountain stand:
NOTE: For easy reference, each leg is labeled.
a.Place the
Bottom Ring
on a flat surface allowing the
ring to slightly hang over for easy alignment and
tightening of screws as shown in Figure 2. Align the
holes of the
Bottom Ring
with the holes on the
Bottom Legs
and PARTIALLY secure by tightening
the screws using the screwdriver provided. Repeat
until all three of the
Bottom Legs
are partially
secure. (Fig 2)
NOTE: DO NOT tighten completely at this point.
b.Insert the
Bottom Legs
into the
Leg Holder
and
adjust so they sit evenly. Now, completely tighten
the three screws in the
Leg Holder
and the three
screws in the
Bottom Ring
. (Fig 3)
NOTE: Before inserting legs, you may need to
unscrew the screws from the
Leg Holder
to allow
for the legs to slide in the holder properly.
c. Insert the
Upper Legs
into the other end of the
Leg Holder.
NOTE: The
Bottom Leg
with the cord clip should
be positioned on the same side of the
Leg Holder
as the
Upper Leg
with the cord clip. DO NOT
tighten screws in
Leg Holder
at this point. (Fig 4)
4
5
Figure 1
Figure 2
Figure 4
Figure 3
(6) Screws in Leg Holder
(6) Screws
(1) Screwdriver
(1) Bottom Ring
(1) Upper Ring
(2) Bottom Leg
(1) Bottom Leg with cord clip
(2) Upper Leg
(1) Leg Holder
Adaptor
Base Cord
Base
Top
(1) Upper Leg with cord clip
Bottom Legs
Bottom Ring
Bottom Legs
Leg Holder
Bottom Ring
Upper Legs
Cord
Clips
Leg Holder
Bottom Ring