Filter
Top Products
6 308765
Setup
General Information
NOTE: Reference numbers and letters in parentheses
in the text refer to the callouts in the figures and the
parts drawing.
NOTE: Always use Genuine Graco Parts and Acces-
sories, available from your Graco distributor. Refer to
Product Data Sheet 305900. If you supply your own
accessories, be sure they are adequately sized and
pressure-rated for your system.
Fig. 2 is only a guide for selecting and installing sys-
tem components and accessories. Contact your Graco
distributor for assistance in designing a system to suit
your particular needs.
Prepare the Operator
All persons who operate the equipment must be
trained in the safe, efficient operation of all system
components as well as the proper handling of all fluids.
All operators must thoroughly read all instruction
manuals, tags, and labels before operating the equip-
ment.
The following manuals are included with this equip-
ment:
D 308765, Pail Mount Airless Packages
D 307619, Monark 23:1 CST and SST Pumps
D 307043, Monark Air Motor
D 308686, Air Regulator Kit
D 307273, Fluid Filter
D 306565, Agitator (Models 232437
and 232449 only)
D 311254, Airless Spray Gun
Prepare the Site
Ensure that you have an adequate compressed air
supply. Refer to the performance charts on page 18 to
find the air consumption of your pump.
Refer to Fig. 2 on page 9. Bring a compressed air
supply line from the air compressor to the pump loca-
tion. Be sure all air hoses are properly sized and
pressure-rated for your system. Use only electrically
conductive hoses. The air hose (A) should have a 3/8
npsm(m) thread.
Install a bleed-type shutoff valve (B) in the air line to
isolate the air line components for servicing. Install an
air line filter (C) and a moisture trap and drain valve
(D) to help remove moisture and contaminants from
the compressed air supply.
Keep the site clear of any obstacles or debris that
could interfere with the operator’s movement.
Have a grounded, metal pail available for use when
flushing the system.