Filter
Top Products
Heatilator • NDI30, NDI30-SP, NDI35, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-900 Rev. G • 4/11 32
Log #4 (SRV2226-703): Position Log #4 as shown in Figure 7. See Figure 1 and Figure 2 for additional details. Place the
top end of log #4 on the fl at spot of Log #1. Position the forked end of Log #4 around the far left grate tine. Rotate the forked
end of the log to the left until the right fork touches the grate tine.
Log #5 (SRV2226-705): Position Log #5 as shown in Figure 8. Refer to Figures 1,2 and 3 for placement references. Position
the two forked ends of Log #5 on the fl at spots of Log #1 and Log #2. The thicker end of the logs rests on the grate bar.
Figure 7. Place Log #4
Figure 8. Place Log #5
Log #6 (SRV2226-704): Position Log #6 as shown in Figure 9. See Figures 1, 2 and 3 for additional details. Rest the forked
end of Log #6 on the fl at spot of Log #2. Position the back end of the log on the fl at spot of Log #1. Figure 10 shows the
log set properly installed.
LOG TOUCHES
GRATE TINE
PLACE TOP END OF
LOG ON FLAT SPOT
LOG TOUCHES
GRATE TINE
LOG RESTS ON
GRATE BAR
END OF LOGS
POSITIONED ON
FLAT SPOTS
Figure 9. Place Log #6
Figure 10. Log Set Installed
LOG POSITIONED
ON FLAT SPOT
FORKED END
RESTS ON
FLAT SPOT
4
5
6
Figure 5. Place Log #3
Figure 6. Log #3
Log #3 (SRV2226-706): Position Log #3 as shown in Figure 5. Refer to Figure 1 and Figure 6 for location of reference
points. Mate the slot located on the bottom of Log #3 with the log pin located on the left side of the burner. Move the left
end of Log #3 forward until it comes into contact with the grate tine.
LOG
TOUCHES
GRATE TINE
MATE LOG
PIN WITH
LOG SLOT
SLOT
3
2226-935