Filter
Top Products
Heatilator • GDST3831I • 2127-900 Rev. K • 7/1246
C. Splatter Guard
The splatter guard is a piece of corrugated material used
to protect the appliance during the installation process
before fi nishing work on the whole hearth is complete.
Splatter guards must be removed before appliance is
fi red.
Risk of Fire
• Splatter guard must be removed before lighting
appliance.
• Before splatter guard is installed:
Close ball valve to prevent accidental lighting.
WARNING
To install the Splatter Guard:
Step 2. Crease fl ap on top side of splatter guard using the
scored line as the guide. See Figure 13.5.
Figure 13.6 Folding Top Flap
Step 3. Crease fl aps on left and right sides of splatter guard
using the scored line as the guide. See Figure 13.6.
Step 4. Center the splatter guard in front of the unit as
shown in Figure 13.8. Place the splatter guard in the unit
by guiding the top fl ap into proper position and then con-
tinuing to guide the tabs on the side fl aps into the top slot
on the left and right sides of the appliance. The top slot
is indicated in Figure 13.9 Take care not to bend or break
off the tabs.
Figure 13.8 Installation of Splatter Guard
Figure 13.9 Top slot
TOP SLOT
Step 1. Turn off gas to valve. Red gas shutoff knob is
located on ball valve. Disconnect the 3 volt transformer
from the junction box. See Figure 13.5.
Figure 13.5 Preparation to Install Splatter Guard
Figure 13.7 Folding of Right and Left Sides of Splatter Guard