TR-0095-RX
© 2008 HeathCo LLC 598-1171-04
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschimecover • Wirelesschimebase
• Wirelesspushbuttonwithbattery • Hardwarepack
This chime requires 2 “C” alkaline batteries (not included). In typical use, alkaline
batterieswilllastuptooneyear.
Wireless Chime
Battery Cover
Battery Cover Catch
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushingintabonbottomwithasmallscrewdriver
(seeFigure1).Seediagraminsidepushbuttonfor
correctbatteryorientation.Note: If batteries are
preinstalled,removeorangebatterytab.
2. Remove chime cover. See page 2 to determine
covermountingtype.
3. Install 2 alkaline “C” batteries. Press in catch
on bottom of battery cover and lift to remove
(seeFigure3).Makesurebatteriesareoriented
properly(seeFigure4).
4.
Test range. Temporarily position chime and push
buttonwhereyouwantthemmounted.Presspush
buttontoverifychimeandpushbuttonworkproperly.
If chime does not sound, see Troubleshooting.
TYPE “C”
TYPE “C”
1 2 3 4 5 6 7 8
Figure 1
WARNING: To prevent possible SERIOUS
INJURY or DEATH:
doctor.
Figure 3 Figure 4
Figure 2