Heath Zenith SL-6200 Door User Manual


 
-2-
598-1144-02
1. Install alkaline type A23 12 volt push button battery.
Remove back of case by pushing in tab on bottom with a
small screwdriver. Make sure battery is oriented properly
(see page 5).
2. Set the push button jumpers for each button to match
the respective chime receiver code. See Code and Tune
Settings section.
3. Test range. Temporarily position push button where you
want it mounted. Press push button to verify chime and
push button work properly. If chime does not sound, see
Troubleshooting.
4. Mount push button. Use either screws or double sided
tape to mount push button.
To mount with screws, remove back of case by pushing in
tab on bottom with a small screwdriver. Remove material
in screw hole. Attach back of case to door jamb or wall.
Snap front of push button on.
When attaching push button using double sided tape,
make sure the surface of the door jamb or wall is clean.
Install This End
Down
Remove material
in screw hole
before mounting
with screws