Filter
Top Products
2
595-4881-10
Typical Installation
1. Remove existing wall switch from junction
box.
2. Connect electrical leads of sensor as shown in
Figure 3. Before installing sensor into junction
box, make sure there is no wire exposed at
each connection.
3. Mount sensor into junction box using two large
mounting screws provided.
4. For test purposes, use a small screwdriver to
turn the TIME control fully counterclockwise
and the LIGHT control fully clockwise. Turn
the power back on at the circuit breaker.
5. Set mode selection switch to the AUTO posi-
tion. When unit stabilizes (about 1 minute),
the sensor is ready to detect motion. If sensor
detects motion, the lights will turn on. The
lights will turn off 5 seconds after motion is
no longer detected.
O
FF
O
N
AU
TO
TIME LIGHT
+
Test 20
151
5 10
Green ground wire to
junction box screw or
grounding wire.
Black
Black Line
“Hot”
Neutral
Return
Lighting Load
WARNING: Turn power off at the
circuit breaker before wiring.
INSTALLING SENSOR
Removing Control Panel Cover
1. Remove the decorative cover plate (secured
by two small screws).
2. Press in with screwdriver as shown in Figure
2. Swing control panel cover out to remove.
Mode
Selection
Switch
Control
Panel
Control Panel
Cover
Figure 2 - Removing Control Panel Cover
Figure 3 - Connecting Electrical Leads of Sensor
To Lighting Load