Filter
Top Products
2
598-1120-04
INSTALLATION
For easy installation, select an existing light with a wall
switch for replacement.
❒ Remove the existing light fixture.
❒ Install the mounting strap as shown using two screws
that fit your junction box.
❒ The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
❒ Route the light control’s wires through the large
gasket holes.
❒ Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
Mount the Light ControL
❒ Align the light control cover plate and cover plate
gasket. Secure with the mounting bolt.
❒ Push the rubber plug firmly into place.
❒ If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone weather
sealant.
White to
White
Lock Nut
To avoid water damage
and electrical shock,
keep lamp holders 30°
below horizontal.
Black to
Black
Gasket
For eave mount only:
❒ Swing the sensor head towards the clamp
screw joint.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
❒ Then rotate the sensor head clockwise 180° so
the controls face down.
Controls
Wall Mount
Eave Mount
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
Mounting
Strap
Mounting
Bolt
Controls
Controls
Clamp Screw
❒ Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the lamps,
do not overtighten.
❒ Install the lamp covers. Align the tabs on the lamp
covers with the holes on the lamp holders. Gently
press lamp covers until the tabs snap into the holes
on the lamp holders.
Keep lamps at least
1" (2.5 cm) from the
sensor. Do not allow
the lamps to block the
lens.
Lens
Rubber
Plug
Push Rubber Plug
Firmly into Place.
Junction box ground wire to
green ground screw on fixture.
Holes for Lamp
Cover Tabs
WARNING: Turn power off at circuit breaker
or fuse.
Wire the Light ControL