Filter
Top Products
6
598-1277-02
❒ If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
❒ Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
❒ Set the amount of time after dusk you want
the lights on accent level.
SPECIFICATIONS
Range .........Up to 30 ft. (9.1 m) [varies with
surrounding temperature].
Sensing Angle ............................Up to 150°
Electrical Load .... Up to 100 Watt Maximum
Tungsten Incandescent
Sensor Capacity ..... Up to 360 Watt (3.0 A.)
Maximum Tungsten
Incandescent
PowerRequirements ......... 120 VAC, 60 Hz
Operating Modes ............ TEST, AUTO, and
MANUAL MODE
Time Delay ........................1, 5, 10 minutes
Du a l Br i t e
®
timer ......................Off, 3, 6 hrs,
Dusk-to-Dawn
❒ Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.
Rotating Sensor Head to Change
Coverage Area
IMPORTANT: Grasp the sensor only as
shown and turn the entire sensor. Any
other method may damage the sensor.
Do not force the sensor past the stop-
ping points.
1
5
0
°
1
5
0
°
BULB REPLACEMENT
If lantern has an open bottom, insert bulb
through opening and screw into socket.
If lantern has a closed
bottom, follow the steps
below to replace bulb.
1. Place one hand
under lower glass
assembly and un-
screw decorative
screws holding
lower glass as-
sembly to top of
fixture.
2. Replace bulb.
3. Reattach lower
glass assembly
to fixture top us-
ing decorative
screws.
Decorative Screws
Lower Glass
Assembly
Light
Bulb