Filter
Top Products
-2- 595-5724-04
Installation
Important considerations: The sensor must be mounted to the door jamb. The
magnet should be attached to the door. Sensor is for indoor use only.
2. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver. See diagram inside sensor for correct
battery orientation.
3. Select mounting location. The maximum gap
between sensor and magnet is 1/2" (13 mm).
The arrows located on the face of each com-
ponent must be aligned and facing toward each
other. The magnet must be beside the sensor.
Note: If the magnet is recessed, use spacer to
ensure proper alignment.
4. Test range. Before mounting, hold sensor and
magnet in selected location and verify opera-
tion. While holding the sensor still, move the
magnet away from the sensor to simulate door
being opened. Verify red LED on sensor flashes
momentarily and chime sounds. Note: If sensor
does not operate correctly, see Troubleshooting
Guide.
Alignment Arrows
WARNING: To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
1/2" Maximum
Use Optional
Spacer if Needed