Filter
Top Products
2
598-1232-02
BLACK WHITE
BLACK BLACK
WHITE
GREEN (Ground) GREEN/BARE (Ground)
TIME
5
25
10
15
1
Test
INSTALLING SENSOR
Typical Installation
1. Remove existing wall switch from junction
box.
2. Connect electrical leads of sensor as shown
in Figure 2. IMPORTANT: Before installing
sensor into junction box, make sure there is no
wire exposed at each connection.
3. Mount sensor into junction box using two large
mounting screws provided.
Figure 2 - Connecting Electrical Leads of Sensor
WARNING: Turn power off at the
circuit breaker before wiring.
TESTING
1. Remove the decorative cover plate (secured by
two small screws).
2. Pinch control panel cover at the indicated points
as shown in Figure 3. Pull to remove cover.
Decorative
Cover
Plate
Figure 3 - Removing Control Panel Cover
Pinch Here Pinch Here