Heath Zenith 598-1172-04 Door User Manual


  Open as PDF
of 24
 
-5-
598-1172-04
TROUBLESHOOTING
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure10).
• Checkorientationofpushbuttonandchimebatteries.(Seediagraminsidepushbutton
andchimeforcorrectbatteryorientation.)
• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.
 Chime is receiving interference from
anotherwirelessdevice;changethecodesetting(seeCode Settingbelow).
 
• Donotmountchimeorpushbuttononmetalornearmetalstuds.Thisreducesthe
transmitterrange.Use1/4"to1/2"(6to13mm)woodshimstomovechimeorpush
buttonoffmetalsurface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:
It is recommended to only change one code position at a time and then check to see if system
isfunctioningproperly.
1. Openthecasesandlocatethejumpersonboththepushbuttonandchime(seeFigure
10).
2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumperpositions1
through7areusedforsettingthecode.
Continued
 previous next