Heath Zenith 598-1172-04 Door User Manual


  Open as PDF
of 24
 
TYPE “D”
TYPE “D”
TR-0035-RX
© 2008 HeathCo LLC 598-1172-04
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschimecover • Wirelesschimebase
• Wirelesspushbuttonwithbattery • Hardwarepack
This chime requires 3 “D” alkaline batteries (not included). In typical use, alkaline batteries
willlastuptothreeyears.
Wireless Chime
Battery Cover
1. Install alkaline type A23 12 volt push button battery
(included). Remove back of case by pushing in tab on bot-
tomwithasmallscrewdriver(seeFigure1).Seediagram
insidepushbuttonforcorrectbatteryorientation.Note: If
batteriesarepreinstalled,removeorangebatterytab.
2. Remove chime cover. See page 2 to determine cover
mountingtype.
3. Install 3 alkaline “D” batteries.Pressdownonimprinted
arrowsandslidebatterycovertoremove(seeFigure3).
Makesurebatteriesareorientedproperly(seeFigure4).
4. Test range. Temporarily position chime and push button
whereyouwantthemmounted.Presspushbuttontoverify
chimeandpushbuttonworkproperly.Ifchimedoesnot
sound, see Troubleshooting.
Mounting
Holes
TYPE “D”
TYPE “D”
TYPE “D”
1 2 3 4 5 6 7 8
V O LUME
WARNING: To prevent possible SERIOUS INJURY
or DEATH:
 
 
Figure 1
Figure 2
Figure 3 Figure 4
Chime Volume
next