Heath Zenith 598-1109-06 Door User Manual


  Open as PDF
of 28
 
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschime
• Wirelesspushbuttonwithbattery
• Hardwarepack
This chime requires 4 “C” alkaline batteries (not included). In typical use,
alkalinebatterieswilllastupto2
1
/
2
years.
Wireless Mechanical
Battery Operated
Chime
©2008HeathCoLLC 598-1109-06
Figure 2
Figure 3
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushingintabonbottomwithasmallscrew-
driver. See diagram inside push button for
correct battery orientation. Note: If batteries
are preinstalled, remove orange battery tab.
2. Remove chime cover.Pullrmlyasshown
inFigure2.
3. Install 4 alkaline “C” batteries in chime.
Make sure batteries are oriented properly as
showninFigure3.
4. Test range. Temporarily position chime and
pushbuttonwhereyouwantthemmounted.
Press push button to verify chime and push
buttonworkproperly.Ifchimedoesnotsound,
see Troubleshooting.
Figure 1
1 2 3 4 5 6 7
ON
Type “C” Type “C”
Type “C”Type “C”
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
     
batteries.
 

next