A SERVICE OF

logo

Open as PDF
next previous
-2-
598-1067-03
4. Adjust volume control (Available on se-
lected chimes). Unplug chime and adjust
volume control to desired volume (see Figure
2).Plugchimebackintowalloutlet.
5. Mount push button.Useeitherscrewsor
double sided tape to mount push button.
• Screw Mounting: Tomountwithscrews,
remove back of case by pushing in tab on
bottomwithasmallscrewdriver(seeFigure
1). Note:Removematerialinscrewholes
(ifneeded)beforemountingwithscrews.
Attachbackofcasetodoorjamborwall(see
Figure 3). Snap front of push button on.
• Tape Mounting:Whenattachingpushbut-
ton using double sided tape, make sure the
surfaceofthedoorjamborwallisclean.
Figure 3
Figure 2
Chime Volume Control
(Selected Chimes)
Jumper Access Door (See
Tune or Code Section)