Heath Zenith 595-5684-09 Door User Manual


  Open as PDF
of 24
 
-4-
595-5684-09
Troubleshooting
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure5).
• Checkorientationofpushbuttonbattery(Seediagraminsidepushbutton
for correct battery orientation.)
• Checkchargeofpushbuttonbattery,replaceifnecessary.
• Makesuretheplug-inchimehaspowergoingtoit.
Chime is receiving
interferencefromanotherwirelessdevice;changethecodesetting(see
Code Settingbelow).

• Donotmountchimeorpushbuttononmetalornearmetalstuds.This
reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims
to move chime or push button off metal surface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:


reconnecting to power.
It is recommended to only change one code position at a time and then check
to see if system is functioning properly.
1.Unplugchimefrompowersource.
2. Open the cases and locate the jumpers on both the push button and chime
(see Figure 5).
3. The push button and chime both have eight different jumper locations. Jumper
positions 1 through 7 are used for setting the code.
 previous next