Filter
Top Products
2 598-1139-02
MOUNTING CHIME ASSEMBLY
1. Position chime assembly over push
button shaft and viewer (see Figure 2).
2. Verify chime assembly is parallel to edge
of door.
3. Attach the top and bottom of chime as-
sembly securely using mounting screws
provided (see Figure 2).
OPERATION
1. Verify door chime operation by pressing
push button. The chime will sound two
(2) notes.
2. If door chime does not operate prop-
erly, check push button and chime
assemblies. Both assemblies must be
parallel to the door edge for proper chime
operation.
3. If necessary, adjust one or both as-
semblies.
ATTACHING CHIME COVER
1. To insure proper clearance when the
cover is attached, break off the excess
push button shaft. IMPORTANT: To avoid
breaking plastic chime assembly parts,
use needle-nosed pliers to hold shaft
securely while bending shaft back and
forth to remove (see Figure 2, View A).
2. Place slot in chime cover over tab on top
of chime assembly.
3. Press bottom of chime cover onto
chime assembly until cover “snaps” into
place.
Push Button As-
sembly (Shown on
Outside of Door)
Chime Assembly
Cover Mounting Tab
Chime Cover
Mounting Screws
Break Off Excess
Push Button Shaft
Cover
Mounting
Slot
Figure 2 - Mounting Chime Assembly and Attaching Chime Cover
Needle-Nosed Pliers
View A