Filter
Top Products
Heat & Glo • ST-36TRB-IPI, PIER-36TRB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI • 2128-900 Rev. H • 8/11 55
Step 5. Fold bottom fl ap along score line as indicated in
Figure 13.6 and tuck into valve access area of appliance.
Splatter guard should fi t securely on front of unit.
Once plumbing and wiring are complete on the fi replace,
the lower access panel may be closed until the time that the
splatter guard must be removed for fi ring the appliance.
Step 6. To open lower access panel of splatter guard, place
one hand above score line and place two fi ngers from other
hand in the round holes on the front of the splatter guard.
See Figure 13.7. Pull out and fold up the panel as shown
in Figure 13.8. Disengage the tabs on left and right bottom
of splatter guard and fi t them into the square holes. The
tabs are now inside the front of the splatter guard; carefully
bend them down. See Figure 13.9.
To Close the Lower Access Panel:
Carefully disengage the tabs from the square holes and
bend the access panel to its original position. Bend the
center bottom fl ap and insert it into the bottom of the ap-
pliance.
To Remove the Splatter Guard:
Carefully grab splatter guard on or near the vertical center
on the left and right sides. Pull outward gently, but fi rmly,
taking care not to tear or remove the inserted tabs.
Figure 13.6 Folding Bottom Flap
Figure 13.7 Prepare to Open Lower Access Panel
Figure 13.9 Securing Tabs Inside Front of Splatter Guard
Figure 13.8 Opening Lower Access Panel
Figure 13.11 Splatter Guard with Lower Access Panel Closed
Figure 13.10 Splatter Guard with Lower Access Panel Open