Filter
Top Products
Heat & Glo • SL-550 / 750 / 950TV-IPI-E • 2119-900 Rev. J • 12/0932
B. Facing Material
• Metal front faces may be covered with non-combustible
materials only.
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
• Seal joints between the fi nished wall and appliance top
and sides using a 300 °F minimum sealant. Refer to
Figure 13.5 and 13.6.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
0 in.
0 in.
0 in.
Finish wall material may be
combustible - Top and Sides
High Temperature Sealant (300° F/149° C min.)
Top and Side Seal Joint
1 in.
NON-COMBUSTIBLE STRIP SHIPPED WITH UNIT
Figure 13.5 Noncombustible Facing Diagram
Figure 13.6 Noncombustible Facing Diagram
0 INCH
(0 mm)
1 INCH
(25 mm)
FINISH WALL MATERIAL
MAY BE COMBUSTIBLE
TOP AND SIDES
TOP SEAL
JOINT
SIDE SEAL
JOINT
NON-COMBUSTIBLE STRIP
SHIPPED WITH UNIT