Filter
Top Products
Heat & Glo • MTL-Insert • 2145-900 Rev. G • 6/0924
Figure 11.5 Glass Assembly
F. Glass Assembly
Removing Glass Assembly
There are two glass latches on bottom of the glass as-
sembly.
• To release glass assembly, pull latch forward and allow
to retract away from glass assembly.
• Remove glass assembly after the bottom two latches
have been released (see Figure 11.5).
Replacing Glass Assembly
• Replace the glass door on the appliance. Fasten the
latches on the glass frame.
G. Air Shutter Setting
Optimal fl ame appearance is dependent on the air shutter
setting. Adjustments should be made by a qualified
technician.
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
WARNING
Model NG LP
MTL-INSERT 3/8 in. Full Open (3/4 in.)
BOTTOM LATCH
GLASS ASSEMBLY