Filter
Top Products
Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K • 6/11 36
2206-935B
Log #3 (SRV2206-702): Position Log #3 as shown in Figure 5. Position the grate tine groove, located on the bottom of the
log, over the base of the left grate tine. Pull the log forward. The back end of Log #3 rests on the log support. Move the
end of Log #3 clockwise until the bottom right corner is fl ush with the pilot bracket.
Figure 5. Place Log #3
Log #5 (SRV2206-704): Position Log #5 as shown in Figure 7. See Figure 6 for additional details. Mate the grate tine with
the log groove as shown. Position the tips of Log #5 on the fl at spots as shown in Figure 6.
Log #4 (SRV2206-703): Position Log #4 as shown in Figure 6. See Figure 3 for additional references. Place the thick end
of Log #4 on the large fl at spot on Log #1. Rest the front end of Log #4 on the fl at spot of Log #2.
FLAT SPOTS
FLAT SPOTS
(FOR LOG #6)
(FOR LOG #6)
POINTS OF LOG REST ON
POINTS OF LOG REST ON
FLAT SPOTS
FLAT SPOTS
GRATE TINE
GRATE TINE
TOUCHES
TOUCHES
LOG GROOVE
LOG GROOVE
Figure 7. Position Log #5
Figure 8. Position Log #6
Log #6 SRV(2206-706): Position Log #6 as shown in Figure 8. See Figure 7 for additional references. Rest the left end of
Log #6 on the fl at spot of Log #3. Position the nose of Log #6 on the fork of Log #5.
FRONT END OF LOG
FRONT END OF LOG
RESTS ON FLAT
RESTS ON FLAT
SPOT
SPOT
REST LOG ON
REST LOG ON
LARGE FLAT
LARGE FLAT
SPOT
SPOT
LEFT END OF
LEFT END OF
LOG RESTS ON
LOG RESTS ON
FLAT SPOT
FLAT SPOT
POSITION THE NOSE ON THE
POSITION THE NOSE ON THE
FORK OF THE LOG
FORK OF THE LOG
CORNER OF
CORNER OF
LOG FLUSH
LOG FLUSH
WITH PILOT
WITH PILOT
BRACKET
BRACKET
3
3
5
5
4
4
6
6
Figure 6. Place Log #4
Figure 9. Log Set Installed
PILOT
PILOT
BRACKET
BRACKET
FLAT SPOTS
FLAT SPOTS
FOR LOG #5
FOR LOG #5