Heat & Glo • EXCLAIM-42C • 4013-094 Rev I • 10/06
26
2 in. (51 mm) min.
4-1/2 in.
(114 mm)
max.
1-1/2 in.
(38 mm) min.
overlap
Cap Standoff
Top of Pipe
Flashing Collar
Figure 6.7 Installing an ST475 Square Termination Cap
• For installations utilizing an ST475 Square Termination
Cap the last chimney section must not be more than
4-1/2 in. (114 mm) below the chase top. See Figure 6.7.
• For chase installations you can use a TR444 Round
Termination Cap, a TR442 Round Telescoping Termination
Cap, or an ST475 Square Termination Cap.
• Install termination caps following instructions provided
with them.