Filter
Top Products
18
Step 9
Before Lighting
the Appliance
Before lighting the appliance, be sure to do the
following:
Review safety warnings and cautions
Read the Safety and Warning Information section
at the beginning of this Installers Guide.
Double-check for gas leaks
Before lighting the appliance, double-check the unit
for possible gas leaks.
Double-check vent terminations and front grilles
for obstructions.
Before lighting the appliance, double-check the unit
for possible obstructions that could be blocking the
vent terminations or the front grilles.
Double-check for faulty components
Any component that is found to be faulty MUST BE
replaced with an approved component. Tampering
with the appliance components is DANGEROUS
and voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the appliance, it will take a few
minutes for the lines to purge themselves of this air.
Once the purging is complete, the appliance will light
and will operate normally.
Subsequent lightings of the appliance will not require
this purging of air from the gas supply lines, unless
the gas valve has been turned to the OFF
position, in which case the air would have to be
purged.
Step 10
Lighting the
Appliance
Youve reviewed all safety warnings, youve checked
the appliance for gas leaks, you know the vent system
is unobstructed, and youve checked for faulty
components. Now youre ready to light the appliance.
WARNING
PLEASE REFER TO THE USERS
MANUAL FOR ALL CAUTIONS, SAFETY,
AND WARNING INFORMATION
PERTAINING TO THE LIGHTING AND
OPERATION OF THE APPLIANCE.
After the
Installation
After the
Installation
LEAVE THIS INSTALLATION MANUAL
WITH THE APPLIANCE FOR FUTURE
REFERENCE.