Filter
Top Products
Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/0842
1-2 IN. THICK
FINISHING
MATERIAL
1-2 IN. THICK
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
37 1/4 IN.
33 3/4 IN.
34 IN.
Figure 11.6 Inside fi t door
Figure 11.7 Operable hinge door
DOOR
FINISHING
MATERIAL
FINISHING
MATERIAL
(Outside door width)
(Includes 1/8 in. opening each side of door)
37 in.
37-1/4 in.
ELBOW
HEAT
SHIELD
Finishing materials over 1 inch thick.
Finishing material between 1 and 2 inches thick.
37 in.
33-3/4 in.
37-1/4 in.
34 in.
(Outside door width)
(Includes 1/8 in. opening each side of door)
Figure 11.5 Overlap Fit Door
C. Finishing Material
It’s very important to know what kind of a door and what
kind of finishing material is going to be used on the
fi replace. The table below shows the door models and the
fi nishing material thickness allowed. For an inside fi t there
is an available template to assist with sizing the fi nishing
material.
Figure 11.4 Folio Door
DOOR FIT
FINISH
MATERIAL
MAXIMUM
THICKNESS
SEE
FIGURE
Folio Inside Any 11.4
Arcadia
Overlap 1 inch 11.5
Inside Any 11.6
Halston
Overlap 1 inch 11.5
Inside 1 inch - 2 inch 11.7
Chateau
Overlap 1 inch 11.5
Inside Any 11.6
Valencia
Overlap 1 inch 11.5
Inside Any 11.6
Galleria
Overlap 1 inch 11.5
Inside 1 inch - 2 inch 11.7
Stop fi nishing material fl ush with opening.
ELBOW
HEAT
SHIELD
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.