Heat Controller HMC30AS-1 Heat Pump User Manual


 
Wrap the insulation material around the
connecting portion.
Overlap the connection pipe insulation material
and the indoor unit pipe insulation material. Bind
them together with vinyl tape so that there is no
gap.
F
Route the indoor tubing and the drain hose to
the required piping hole position.
A
Insert the piping, drain hose and the connecting
cable into the piping hole.
B
Plastic bands
Insulation material
Drain pipe
Connecting cable
Vinyl tape(narrow)
Connection
pipe
Connecting cable
Vinyl tape
(wide)
Wrap with vinyl tape
Indoor
unit pipe
Pipe
Connection pipe
Flare nut
Indoor unit tubing
Torque wrench
Spanner (fixed)
Vinyl tape(narrow)
Adhesive
Drain pipe
Indoor unit drain hose
When extending the drain hose at the indoor unit,
install the drain pipe.
Tighten the flare nut with a wrench.
Pipe Size[Torque]
Capacity
(Btu/h)
Suction Evaporator
Wrap the area which accommodates the rear
piping housing section with vinyl tape.
Bundle the piping and drain hose together by
wrapping them with vinyl tape over the range
within which they fit into the rear piping housing
section.
For right rear piping
Wrap with vinyl tape
Drain hose
Pipe
Vinyl tape(wide)
Drain hose
8
Connecting the pipings to the indoor unit and
drain hose to drain pipe.
Put a couple drops of refrigerant oil on the face of
the flare before assembling taking care not to
add any contaminants.
Align the center of the pipings and sufficiently
tighten the flare nut by hand.
E
Indoor unit tubing Flare nut Pipings
30k 5/8"[6.6kg.m] 3/8"[4.2kg.m]