10
Reroute the pipings and the drain hose across
the back of the chassis.
Reinstall the parts to the original position.
■ Refix the lower panel to the original position.
■ The chassis bottom(A) should be connected to
the steel chassis(B) with green/yellow wiring
using two screws.
■ Connect display conductor.
■ Refix the front right side panel to the original
position with the two screws.
H
Piping for
passage through
piping hole
A
Green / Yellow wire
Green / Yellow wire
B
Main PCB
I
Drain hose
Vinyl tape(narrow)
Pipe
Wrap with
vinyl tape(wide)
■ Bundle the piping and drain hose together by
wrapping them with cloth tape over the range
within which they fit into the rear piping housing
section.