Filter
Top Products
7 Hearth & Home Technologies Inc. • SFE-ST • 4050-510 Rev A • 05/08
3
3
Service Instructions
4
4
Service Parts
3
7
10
8
4
4
2
1
6
5
3
9
1 Viewing Screen 4050-500
2 View Screen Retainer 4050-501
3 Glass Door (each side) 4050-502
4 Refractory (each side) 40505-503
5 Fuel Bed 4050-504
6 Embers LED Assembly 4050-505
7 Projector Assembly 4050-506
8 Power Supply Assembly 4050-507
9 3 Watt LED Bulb 4050-508
10 Receiver 4050-108
n/s Installation Manual 4050-510
n/s Wall Switch WSK-21
A. Replacing the Light Bulb
This appliance uses a single 12 Volt, 3 Watt, MR-16 LED
bulb.
• Turn off power to the unit at the main service panel.
• Remove the glass door by lifting up and in.
• Remove the two screws on the projector basket.
• Rotate the housing down to access the bulb.
• Remove the screws holding the bulb and socket.
• Unplug the bulb from the socket.
• Replace the bulb.
• Re-assemble in the reverse order.
WARNING! Disconnect power at circuit breaker before
attempting any maintenance or cleaning to reduce the
risk of fi re, electrical shock or personal injury.
B. Screen Cleaning
During shipment, installation, handling, etc., the screen
surface may collect dust particles; these can be removed
by lightly wiping with a clean, dry cloth.
C. Maintenance of Motors
The motors used on the fl ame projector assembly is pre-
lubricated for extended bearing life and requires no further
lubrication.