Filter
Top Products
Quadra-Fire • Village Collection Electric Fireplace • 4030-240 Rev J • 04/05
8
C. Framing
Figure 3.2 shows a typical framing (using 2 x 4 lumber) of
the heater, assuming combustible materials are used. All re-
quired clearances to combustibles around the heater must
be adhered to.
36-1/4 in.*
(921 mm)
14 in.
(356 mm)
31-1/4 in.*
(794 mm)
Header Height
*If using the PBT or BKT Cabinet Trim Kits,
increase the width by 1-1/4 in. (32 mm) and
header height by 5/8 in. (16 mm).
Mantel height listed is measured
from the BASE of the heater.
3/4 in. - 12 in.
(19 mm - 305 mm)
31-1/2 in.
(800 mm)
(CEILING)
30 in. min.
(762 mm)
Figure 3.2 Framing the Heater