Filter
Top Products
Quadra-Fire • Village Collection Electric Fireplace • 4030-240 Rev J • 04/05
14
A. Remove Shipping Materials
Cut and discard ties securing logs to grate and bundling
the fi rescreen. Remove screws holding ember bed shipping
tabs in place (located in front of ember bed). Remove tabs
and discard. Replace screws.
B. Clean Heater
The heater was cleaned at the factory but dust may have
accumulated during shipping.
• Vacuum fi rebox area and wipe acrylic panel (in back of
fi rebox) with a dry, lint-free cloth or paper towel. DO NOT
USE GLASS CLEANER! It will ruin the acrylic panel.
• Remove all fi ngerprints and smudges from front trim to
avoid permanently burning them into fi nish.
C. Accessories
Refer to instructions included with accessory.
D. Install Refractory
Remove protective cover to access fi nal installation items.
Remove Log Assembly
Logs are attached to the grate by two zip-ties. Carefully cut
both ties by using a utility knife or side cutters. Discard ties
and packaging material. Lift log set straight up and place in
safe place.
Install Side Refractory
• Remove the refractory and fasteners from the carton.
• Take the refractory support bracket and bend it until it is
L-shaped.
• Install the bracket to the underside of the fi rebox top using
the screws provided. Keep the bracket loose to allow the
refractory to slide in behind it.
• Tilt the side refractory into the heater and slide it behind
the bracket. See Figure 7.1.
• Tighten the bracket when the refractory is resting on the
hearth and is up against the back acrylic panel.
• Repeat for the other side.
7
Heater Setup
Figure 7.1 Sliding Side Refractory Behind Bracket
(right side shown)