Filter
Top Products
Page 30
10/08
Quadra-Fire • Hudson Bay • 7003-121 Rev. i
F. Positioning the Logs
Figure 8.13 Log Set.
Figure 8.14 Logs shown installed in fi rebox. Logs #1 and #2 are
part of the burner pan and are numbered for reference only.
Figure 8.11 Install the rear brick. Slide it in at an angle and place
over the rear brick retainer. Hand bend retaining tabs up to
hold brick in place. Push baffl e towards back of fi rebox.
Figure 8.12 NOTE: For the Hudson Bay Free Standing the
upper rear brick retainer is used.
Rear brick retainers
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
#3
#4
#5
#6
#1
#2
#3
#4
#5
#6
Figure 8.15 Install the left rear log (#3) over the locater pins
in the burner pan.
Figure 8.10 Bend retaining tabs on left and right sides inward
to hold brick in place.
2 retaining tabs
on right and left
sides
Reinstall the pilot shield with the screws removed in Figure
8.6. The pilot shield must be in place before operation of
appliance.