Filter
Top Products
Hearth & Home Technologies • GFK4B Fan Kit • 4016-095 Rev H • 11/08
2
1. Install the Air Defl ector
Open the bottom front panel by lifting and pulling it away
from the appliance. Attach the air defl ector and green ground
wire with two screws to the front of the blower output. See
Figure 1.
Air
Deflector
Figure 1 Install Air Defl ector
Note: Novus appliances do not require the use of the air
defl ector. Attach the green ground wire with the screw in
the existing hole.
• If the fan is being installed in a B-vent appliance, the fan
shield supplied with the appliance will also need to be
attached. See Figure 4.
2. Install the Fan Bracket & Shield
• Place the fan bracket around the fan. See Figure 2.
• Install the two screws through the fan bracket into the
back of the fan housing to hold the bracket in place. See
Figure 3.
• If no fan shield is needed, install screws to hold the front
of the fan bracket in place. See Figure 5.
• Attach the foam tape (Figure 3) and magnets (Figure
6) to the fan. Cut one magnet strip in half and save the
remaining strip for control module.
Figure 3 Insert Screws
Figure 4 Fan Shield
Figure 6 Magnets
Figure 2 Fan Bracket-No screws
Figure 5 Fan Bracket