Filter
Top Products
September 1, 2008
Page 7Quadra-Fire · Garnet-T · 7016-127F
3
Appliance Location and Clearances
A. Selecting Appliance Location
NOTE:
· Illustrations reflect typical installations and are FOR
DESIGN PURPOSES ONLY.
· Illustrations/diagrams are not drawn to scale.
· Actual installation may vary due to individual design
preference.
When selecting a location for your appliance it is important to
consider the required clearances to walls (see Figure 3.1).
WARNING
Fire Risk
Provide adequate clearance:
• Around air openings
• To combustibles
• For service access
Locate appliance away from traffic areas.
Fire Risk.
• Locate and install appliance to all
clearance specifications in manual.
WARNING
B. Clearances
Figure 3.1
Model ABCDEF G H
Garnet-T
Inches
6 2 2 43 36 30 19-1/2 19-3/8
Millimeters
152 51 51 1092 914 762 495 492
NOTE: Flooring beneath appliance may reach 90 degrees
plus room ambient temperature. Check with flooring
manufacturer for maximum temperature allowed on flooring
surfaces.
It is permissible to place the appliance on carpet.
CAUTION
Some carpet materials may be sensitive to radiant heat from the
appliance causing discoloration or odor.
Fire Risk.
Odor Risk.
Tipping Risk
• Install appliance on a stable, level platform/
floor strong enough to support appliance
without tipping.
•
USE wood flooring, ceramic tile, brick hearth
or high pressure laminate flooring applied
directly over the sub-flooring material.
WARNING
A
H-Alcove
A
D
C
A
B
F
E
A
"A" measurement is from
stove top, not side
C
G
NOTE: For actual appliance dimensions refer to
Section 12.