Filter
Top Products
Page 32
September 1, 2008
Quadra-Fire · Garnet-T · 7016-127F
D. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
Shock or fire risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING
E. Positioning the Logs
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
Figure 8.6 Gently remove top of unit and set aside. Remove
cast face by sliding straight up and set aside. Remove the
glass by releasing the latch located on the top of the appli-
ance. Lean glass frame forward and lift out.
Place the notch in the Rear Log over the pilot assembly.
Push the log all the way to the rear of the firebox.
Figure 8.7 Align left front log with notch in burner and notch
on rear log
.
Qty Name Diagram
1 Rear Log Fig. 1
1 Left Log Fig. 2
1 Right Log Fig. 3
The three piece log set is packed in the components
box and consists of the following:
Figure 8.8 Align right front log with burner and notch in left
front log.
F. Mineral Wool
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Figure 8.9 Place individual pieces of embers in front of and
around the gas log where they can be seen. Space them so
that gas can contact them on all sides. Avoid stacking the
embers on top of each other.
NOTE: Do not block gas ports.