Filter
Top Products
Page 20
September 1, 2008
Quadra-Fire · Garnet-T · 7016-127F
4. Existing Masonry Chimney
Figure 5.24
Type C - Up & Out Installation
Type A & B - Co-Axial to Co-Linear
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear
Connector
25 ft. (8m) of 3 in.
(76mm) Flex Liner
Exhaust Section
Pipe Length
Optional
4 ft. (1m) of 3 in.
(76mm) Flex Liner
Air Intake Section"
4
ft
The chimney must be sealed from
the 4 ft. (1m) section to
termination using a smoke shelf
or a damper. The seal should be
6 in. (152mm) below the end of
the 4 ft. (1m) Air Intake section.
This section of the
chimney must be
sealed
Chimney Liner
Termination Cap
25 ft. (8m) of 3 in.
(76mm) Flex Liner
Exhaust Section
4 ft. (1m) of 3 in. (102mm)
Flex Liner
Air Intake Section"
Chimney must be sealed
from 4 ft. (1m) section to
termination using a smoke
shelf or a damper*. Seal
should be 6 in. (152mm)
below end of 4 ft. (1m) Air
Intake section.
This section of the
chimney must be sealed
Co-Axial to Co-Linear Connector
Alcove Clearance to
Combustibles must
be maintained.
Type D - Hearth Mount
Type A
Type B
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear
Connector
3 in. (76mm)
Flex Liner
Pipe Length
Optional
Showing two 35 ft.
(11m) Sections of
Flex Liner
TERMINATION CAP
FLASHING
4 in. (102mm)
FLEX LINER
TOP ADAPTOR
RETRO
CONNECTOR
90° ELBOW
DIRECT
VENT PIPE
*In the Commonwealth of Massachusetts, the word damper
shall be replaced with the words flue restrictor.