Filter
Top Products
Heat & Glo • 8000CF-OAK-IPI • 2059-900 Rev. Q • 11/08 49
H. Install the Log Assembly
Log Assembly: LOGS-8OAK
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
CAUTION: Carefully remove the logs from the packaging.
Logs are fragile!
STEP 1: Remove metal grate supports (A) and refractory
tabs (B) by using a back and forth motion until the tabs break
free. Metal tabs and supports are needed for shipping only.
After removing the tabs and supports, the grate should fully
rest on the base refractory.
STEP 2: Log #1 (SRV2057-720): Place log 1 so that the
bottom right notch on log rests on far right grate tine. The
bottom left notch on log #1 must mate over the log tab on
the burner face.
1
STEP 3: (SRV2057-721): Place log 2, nose to nose with
log 1. The bottom notch on log #2 must mate over the log
tab on the burner face.
STEP 4: (SRV2057-722): Place log 3 so that the bottom notches mate with the 2 back steel tabs. Tab A is located on the
right side of pilot bracket, tab B is located at the back/right corner of burner. NOTE: There should be a 1/2 inch gap between
the bottom of log 3 and the top edge of the burner. The underside of log #3 must not cover ANY burner ports.
2
1
2
1
A
B
2
1
3
A
B
2057-935C
A
B
B
A
B
LOG TAB
LOG TABS